Automotive » Oxygen Sensor Removers

Pneumatic Action Removes Oxygen Sensors. Use this set with an air hammer to remove stubborn baked-on oxygen sensors. The pneumatic action works where conventional sockets wont. The compact design allows easy access under the hood. To install sensors use the socket only with a 3/8 drive ratchet.

Oxygen Sensor Flexhead Wrench 22mm size covers 90% of all vehicles. Adjustable head allows for easy access to hard to reach places. Long handle provides extra torque. Lifetime Warranty

22mm size covers 90% Of all vehicles has adjustable head to allows for easy access to hard to reach places, long handle provides extra torque. Lifetime Warranty.

Oxygen Sensor Wrench. Easily removes the oxygen sensor located in the exhaust manifold. Heat treated cast steel. Has 7/8" hex, 1/2" square drive (double square for easy access). Same as Ford No. T79P-9472-A. Weight: 8oz.

7/8" Oxygen Sensor Socket Removes & installs oxygen sensors on most domestic & some imports. Special 7/8" socket w/ cutaway slot to provide clearance for wire harness. Provides adequate depth to fit over sensor. Heat treated alloy steel. Use w/ 3/8" square drive or 1" wrench. Shipping weight 9 oz.

OTC 7807 Reinforced tool for removing heated oxygen sensors without rounding them off. This wrench was designed to accommodate connectors on heated oxygen sensors that are too large to fit through the standard O2 sensor wrenches. Removes the toughest sensors without rounding them off.

Heated Oxygen Sensor Wrench A slot was designed in the side of this wrench to accommodate connectors on heated oxygen sensors that are too large to fit through standard 02 sensor wrenches. The extended and reinforced design removes the toughest sensors without rounding them off. Has a 1/2" ...

8 pc. Master Sensor Socket Kit Designed for the removal and installation of oxygen sensors, oil pressure sending units, and vacuum switches.

Fits most all oxygen sensor no matter what size electrical connectors they have. The SP88750 allows easy access to the oxygen sensor, which is often located in a very confined area. The SP88750 even fits into the area above the catalytic converter on 16 valve VW GTIs.

Oxygen Sensor Wrench - 2-1/8" OffsetFeatures: This wrench was designed for use with most all oxygen sensors no matter what size electrical connectors they have. This wrench was developed to access oxygen sensors on LTI Gen II 5.7L HO MPFI V8 found in the 1992 and later Corvette, 1993 and later ...